Method for the Design of a Contact Dryer-Application to Sludge Treatment in Thin Film Boiling - IMT Mines Albi-Carmaux Accéder directement au contenu
Article Dans Une Revue Drying Technology Année : 2004

Method for the Design of a Contact Dryer-Application to Sludge Treatment in Thin Film Boiling

Résumé

A method, based on the analysis of heat transfer is developed for the design of contact dryers in thin film boiling for sludge treatment. An experimental device was built in order to estimate the heat flux density exchanged between a hot metallic plate and the drying sample. This specific device is made of a thick copper plate heated at a temperature above 100°C, on which the sludge is coated. The contact temperature and the heat flux density are estimated using a temperature sensor inside the copper block and an inverse conduction method (Beck's sequential function specification method). The corresponding drying curve is deduced from an energy balance. Sludge drying was studied on an electrically heated laboratory continuous drum dryer. A simple steady state model of the drum dryer was developed by taking into account the combined effects of internal and external transfers. This model is validated by comparison with drying curves obtained from sampling and simulation. In this case, the relative importance of internal and external heat transfers is highlighted.
Fichier principal
Vignette du fichier
Paper_HAL.pdf (456.72 Ko) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)
Loading...

Dates et versions

hal-01165286 , version 1 (18-06-2015)

Identifiants

Citer

Didier Lecomte, Olivier Fudym, Christine Carrere Gee, Patricia Arlabosse, J. Vasseur. Method for the Design of a Contact Dryer-Application to Sludge Treatment in Thin Film Boiling. Drying Technology, 2004, 22 (9), p.2151-2172. ⟨10.1081/LDRT-200034229⟩. ⟨hal-01165286⟩
215 Consultations
427 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More